PRO-POINT 9082694 Manuel page 7

V1.0
Remove the parts and accessories from the packaging and inspect for
damage.
Make sure that all items in the parts list are included.
Numbered references in parenthesis (#1) refer
to the included Parts List.
Dashed numbers in parenthesis (Fig. 1-1) refer
to a specific point in an illustration or image.
1. Assemble the protective shield (#19)
using the hex nuts (#20), flat washers
(#13) and pan-head screws (#12). Make
sure the screws are properly tightened (Fig. 1).
2. Once completed, it should resemble Fig. 2.
1. Remove the grinding wheel and shield, keeping the
nut (#5) and wheel flange (#6) in a safe location for
future applications (Fig. 3).
2. Put the locating sleeve jig (#44) on the
motor shaft against the motor end cap
(Fig. 3).
3. Install the sanding belt frame onto the
motor shaft using the flat washers (#9)
and screws (#8). Ensure they are
properly tightened (Fig. 3).
4. Take the locating sleeve out and keep
for future applications.
5. Once completed, it should resemble Fig. 4.
Visit www.princessauto.com for more information
8 in. Belt Grinder Attachment
2
9082694
Fig. 1
Fig. 2
Fig. 3
Fig. 4
7