Proxxon OZI 220/E Mode D'emploi page 7

Important:
Unplug machine before replacing or
turning wheel!
1. Remove grinding wheel (Fig. 3)
2. Detach screw 2 (Fig. 1) using Allen
wrench. In the event that screw is
jammed, exert load moment against
grinding pad to avoid unnecessary
mechanical stress.
3. Replace grinding pad, or rotate to
desired position.
4. Re-tighten screw without exceeding
tightening torque of 5 Nm.
Important!
Possible attachments include circular
saw blades and diamond cutting blades
(Fig. 4). Always ensure that only suitable
attachments are used. Always observe
the relevant safety precautions.
Operating the machine
Important!
Always wear protective goggles when
operating the machine.
1. Switch on machine at switch 4
(Fig. 1) and set the appropriate speed
at button 3.
Note:
For optimal grinding, apply requisite
uniform speed. Applying excessive
pressure does not achieve improved
grinding results and increases heat build-
up.
2. When holding machine, do not
occlude vent slits 7 (Fig. 1).
Note:
In the event that machine overheats,
switch it off immediately and allow to
cool.
Care and maintenance
Important!
Unplug machine prior to maintenance!
Always ensure that vent slits remain
unobstructed.
Check power supply cable at regular
intervals for damage. In the event that
cable is damaged, have a qualified
technician replace it.
Disposal:
Please do not dispose of the device in
domestic waste! The device contains
valuable substances that can be
recycled. If you have any questions
about this, please contact your local
waste management enterprise or other
corresponding municipal facilities.
EC Declaration of Conformity
We assume sole liability for ensuring that
this product conforms with the following
EC guidelines:
• EC Low Voltage Guideline
73/23 EEC; 93/68 EEC
• DIN EN 60745-1 / 12.2003
• DIN EN 60745-2-11 / 12.2003
• EC-EMC Guideline 89/336/EEC
• DIN EN 55014-1 / 09.2003
• DIN EN 55014-2 / 08.2002
• DIN EN 61000-3-2 / 12.2001
• DIN EN 61000-3-3 / 05.2002
• EC Machine Guideline
98/037 EEC
• DIN EN 60745-1 / 12.2003
• DIN EN 60745-2-11 / 12.2003
Dipl.-Ing. Jörg Wagner
05.09.2005
PROXXON S.A.
Equipment Safety Division
- 7 -