Setup And Use - Summit Treestands Dual Performer Mode D'emploi

5

SETUP AND USE

PLATFORM RATCHET STRAP
1. Attach the Ratchet with Loop End to the yolk tube at
location A as shown in figure 28. Put the sewn loop around
the tube (figure 29) and then push the ratchet through the
loop (figure 30) to create a cinch knot as shown in figure
31.
2. Attach the Short Strap for the Ratchet to the opposite
yolk tubing at location B shown in figure 28. Loop the
free end of the strap around the tube and then through the
sewn loop. Pull to create a cinch knot. This is the platform
tie down ratchet strap.
29
LADDER STABILIZER STRAPS (CAM BUCKLE)
1. Attach the two Long Stabilizer Straps to the yolk tube
at locations A and B in figure 28. Use the same procedure
from Step 1 above to create a cinch knot for each strap.
These are the two main ladder stabilizer straps.
2. Attach the Cam Buckle end of each strap to the bottom
ladder column between the second and third rungs as
shown in figure 32. Use the same procedure to create a
cinch knot.
3. Before setup, run the Long Stabilizer straps to the Cam
Buckles and thread the free end of the strap through the
cam buckle as shown in figure 33. Pull the free end on both
straps until they are tight.
These two straps provide support to the ladder column
while you are setting your stand up and double as Stabilizer
straps once the stand is in place.
WARNING
!
Never Wrap The Stabilization Straps Around The
Ladder Rungs! Wrap Them Only Around The Ladder
Columns! (see figure 32)
SEAT STRAP (CAM BUCKLE)
1. Attach the seat straps next. Use the shortest of the Cam
buckle strap and wrap it around the seat frame at location C
shown in figure 28. Loop it and create a cinch knot.
2. Attach the remaining short strap to the seat at location
D in figure 28. Use the same procedure to create a cinch
knot.
30
28
C
B
31
32
33
D
A
PG 9