Summit Treestands Dual Performer Mode D'emploi page 5

SUPPORT BARS / SEAT BACK (continued)
5. Position the Seat Back next. The teeth area on the Seat Back
bar should face the tree when finished as shown in figure 11.
6. Line up the Seat Back with the holes in the Yoke and Seat Base.
Secure using two 3 1/2" bolts and lock
7. Wrench tighten the bolts from Step 4.
11
GUNREST
1. Slide the Gunrest Bar onto the Left and Right Gunrest Arms as
shown in figure 13.
2. Secure the Gunrest Bar using two
figure 14. The Wire Lock Pins allow adjustment of the Gunrest Bar by
sliding it in or out.
13
GUNREST
BAR
(PN 82064.710)
RIGHT
GUNREST ARM
(PN 82064.730)
3. Insert two of the Rubber Gunrest Bumpers
drilled holes on each Armrest (see figure 15). Insert by pushing
while twisting slightly.
4. Each Gunrest Arm has a tab with a pre-drilled hole. Line
up these holes with the holes in the Armrests. Insert one
Bushings between each Gunrest tab and each Armrest hole
(figure 16).
5. Use two 1 3/4" bolts with lock nuts
armrest (see figure 17.) Do not overtighten.
6. Position the Gunrest Pad as shown in figure 18. Secure by
wrapping the pad around the bar and using the hook and loop
strip to secure.
nuts. (see figure 12)
SEAT BACK
(PN 82064.500)
1/4" Wire Lock Pins as shown in
LEFT
GUNREST
ARM
(PN 82064.720)
into the pre-
1/4"
to secure the bar to the
3 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
12
DO NOT use the Gun Rest Bar as a hand hold while
climbing into our out of this stand.
1/4" WIRE LOCK PINS
14
15
CAUTION
!
RUBBER
GUNREST
BUMPERS
PG 5