Summit Treestands Dual Performer Mode D'emploi page 4

PLATFORM / SEAT BASE (continued)
7. Secure the Upright to the Platform and Seat using three
(See figure 6)
8. Position the remaining Armrest Upright on the opposite side as shown in figure 7. Attach the upright arm using three
bolts and lock nuts.
9. Once both Armrest Uprights are attached, wrench tighten all bolts from Steps 4, 7 and 8.
2 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 9
6
SUPPORT BARS / SEAT BACK
1. Position the Platform Support bar as shown in figure 8.
2. Attach using two 2 1/2" bolts and lock
3. Slide the Yoke onto the Seat Base as shown in figure 9.
4. Line up the outside holes and attach to the Seat Base using
two 2 1/2" bolts and lock nuts
hand tight for now.
9
YOKE
(PN 82064.400)
PG 4
nuts.
(see figure 10). Leave these
2 1/2" bolts and lock nuts. Leave these bolts hand tight for now.
7
8
2 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 7
10
ARMREST
UPRIGHT
(PN 82064.010)
PLATFORM
SUPPORT
(PN 82064.020)
www.summitstands.com
2 1/2"