Summit Treestands Watchtower Tripod-12 Mode D'emploi page 9

36
3 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
38
BRACKET
(PN 82072.1300)
39
2 3/4" BOLT, LOCK NUT,
41
WRENCH TIGHTEN
COUPLER
PLATE
(PN 82072.1000)
BRACKET
(PN 82072.1300)
LEG ASSEMBLY / LEG BRACES
1. Carefully lay the completed top section on its side - ladder rungs
up as shown in figure 36.
2. Position one of the Couple Plates as shown in figure 37. Slide the
plate over the leg, between the Upper Ladder Assembly and line up
the holes. NOTE: Coupler Plate must line up with the round holes
and not the oval holes.
3. Position one of the Brackets as shown in figure 38. The bracket
should be bolted to the Coupler Plate so that it runs horizontal when
the tripod is sitting upright.
4. Use one
Coupler Plate.
5. Position the 12' Ladder Assembly as shown in figure 39.
6. Slide the Assembly into the Coupler Plate and secure with one,
3/4" bolt and lock nut.
12' LADDER
ASSEMBLY
(PN 82072.1100)
7. Carefully rotate the tripod assembly to gain access to one of the
legs.
8. Slide another Coupler Plate on the Leg and line up the round
holes as shown in figure 41.
9. Position one Bracket as shown in figure 41 and secure using one
3/4" bolt and lock nut.
Hardware Needed
5/16X18 - 2 3/4" Bolt - 8
5/16X18 - 3 3/4" Bolt - 1
5/16X18 - Lock Nuts - 9
3 3/4" bolt and lock nut
37
(see figure 40)
2 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
40
1/4X20 - 1 1/2" Bolt - 12
1/4X20 - Lock Nuts - 12
to secure both the Bracket and
COUPLER
PLATE
(PN 82072.1000)
PG 9
2
2