Summit Treestands Watchtower Tripod-12 Mode D'emploi page 8

Hardware Needed
1/4X20 - 1 1/2" Bolt
1/4X20 - Lock Nut
COMPLETED
29
SEAT ASSEMBLY
31
SEAT BACK
(PN 82073.950)
34
PG 8
- 4 Steel Washers
- 4
35
SEAT ASSEMBLY ATTACHMENT
1. Position the completed Seat Assembly over the Tripod Base
- 4
as shown in figure 29. It may be helpful to have a helper
complete this step.
2. Secure the Seat Assembly to the Swivel using four
bolts and lock nuts. Use 1/4" Steel Washers between the lock
nuts and the swivel plate. You may need to rotate the Swivel to
gain access to the bolts. See figure 30.
1 1/2" BOLTS, LOCK NUTS,
WRENCH TIGHTEN
30
SEAT / PAD ATTACHMENT
1. Position the mesh Seat Back in the frame as shown in figure 31.
2. Bring the top two webbing loops together and thread the rope
through leaving equal lengths on both ends. See figure 32.
3. Lace the seat using the rope, criss-crossing between the webbing
loops all the way down as shown in figure 33.
4. At the bottom, run the remainng rope back up through the last
webbing loop and tie off as shown in figure 34.
32
5. The Foam Seat Base sits on the frame. Use the
loops to secure it around the Seat Frame.
ARM PAD
6. The two short Arm Rest Pads attach as shown in
(PN 82073.800)
figure 35. Use the Velcro strips to secure them to the
frame.
7. The Gunrest Pad attaches the same way across the
long gunrest bar.
STEEL WASHER
(not shown - PN SU10625)
33
1 1/2"