Summit Treestands Watchtower Tripod-12 Mode D'emploi page 11

LEG BRACES (continued)
4. The six Cross Braces will attach next. Start by positioning
one Cross Brace as shown in figure 46. This Brace will bolt
to the OUTSIDE of the two Brackets, as shown in figure 47
and figure 48.
5. Use one 1 1/2" bolt and lock nut
secure the Brace. Run these bolts from the inside out so
that the nut is on the outside of the tube.
47
49
50
at each Bracket to
1 1/2" BOLT, LOCK NUT -
WRENCH TIGHTEN
CROSS
BRACE
(PN 82072.1400)
1 1/2" BOLT, LOCK NUT -
WRENCH TIGHTEN
46
48
6. Position one Cross Brace
49. This Brace will bolt to the INSIDE of the two Brackets,
as shown in figure 50 and figure 51 and it will sit on the
INSIDE of the Brace installed in Steps 4 - 5
7. Use one 1 1/2" bolt and lock nut
secure the Brace. Run these bolts from the inside out so
that the nut is on the outside of the Bracket.
51
CROSS
BRACE
(PN 82072.1400)
(in blue) as shown in figure
(shown in green)
at each Bracket to
PG 11