Summit Treestands Watchtower Tripod-12 Mode D'emploi page 12

LEG BRACES (continued)
8. Walk around to the opposite side of the Tripod.
Attach one more Cross Brace
OUTSIDE of the Bracket and one more Cross Brace
(in blue) to the INSIDE of the Bracket. See figure 52.
Figure 53 shows the correct placement of braces. Each
Cross Brace should alternate - with the
always bolting to the outside of the bracket and the
Blue Braces always bolting to the inside.
9. Use
1 1/2" bolts and lock nuts
point.
53
OUTSIDE
10. Rotate the tripod so that you can bolt up the last
two Cross Braces. These Braces attach the same way.
See figure 54. The Cross Brace
the outside of the Bracket while the Cross Brace
blue) attaches to the inside of the Bracket. Use
bolts and lock nuts at each connection point.
11. The finished Leg Brace setup should look like
figure 55. Note that the green
outside and the blue Cross Braces are on the inside.
55
PG 12
(in green) to the
Green Braces
at each connection
BRACKET
(PN 82072.1300)
INSIDE
(in green) attaches to
(in
1 1/2"
Cross Braces are on the
52
54