pewag snox SX Instructions De Montage page 8

Mounting
Make sure that the blue lock (quick release) is closed – green
1
car visible in the window.
Pull the red ring near the red box apart. Put the red box from
2
the top over the tire. The red box must be positioned on the
inner side of the tire.
Pull the red ring down firmly using both hands. Position the
3
red ring as far as possible behind the tire. Take care that the
blue clips – on the red ring – are not twisted.
Pull the red ring down until it is positioned between the tire
and the street. Take care that the plastic clips do not lay on
4
the tread on top of the tire.
Drive your car forward or reverse it by 1/4 a rotation of the
wheel (wheels may not spin). Recommendation: Move the
5
vehicle downhill.
Move the red ring completely to the inner side of the tire. The
chain must be arranged correctly (not twisted). Take care that
6
the blue clips – on the red ring – are not twisted.
This is how the chain looks when it is mounted correctly. Drive
7 a few meters at walking speed. Recheck for a correct fit of the
chain after approx. 50 m.
MOUNTING COMPLETED
EN
Demounting
Stop your car in such a way that the blue lock (quick release)
1
is on top. Press the red latch – a car crossed-out in red
is visible.
Grab the chain in the area of the tire tread and pull it firmly to
2
the front (release chain strings if they are jammed in the tread
of the tire).
3 By pulling firmly, the red ring slips from the rear side to
the front.
4 Pull the chain in front of the tire. Take care that the chain is not
twisted at the drive-off area. Drive the car forward or
reverse it slightly. Recommendation: Close the blue lock
(quick release) for the next use.
DEMOUNTING COMPLETED