Takeoff; Rc Functions - XciteRC FunSky RTF orange Mode D'emploi

• Switch the transmitter on, the transmitter beeps once (Di).
• Remove the canopy. Connect the flight battery (1) and insert into the battery bay (2). The transmitter
beeps twice now (Di-Di).
EN
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• NOTE: the model is trimmed with the battery. If the model sinks (nose downwards) with the elevator
stick in neutral, slide the battery backwards (2). If it rises, move the battery more towards the aircrafts
nose (3), until the model flies neutral.
• Place the canopy in position.
• Move the left throttle lever all the way up until the transmitter beeps once, and then back to the lowest
position - the transmitter beeps again. This safety circuit prevents the rotor may start after switching on
the transmitter.
• Now the model is ready for takeoff.
• If the flight battery runs low, the motor power starts to get weak and the model can hardly hold the alti-
tude. From now on the model is controllable for one or two more minutes only. Find a suitable landing spot
and land. Charge the flight battery again.
• trollable for one more minute only. Find a suitable landing spot and land. Charge the flight battery again.

Takeoff

Hold the model underneath the wings in one hand and give full throttle with the other hand on the transmitter.
Now throw the model with a slight forward momentum away and give a little elevator up at the transmitter so
that the model quickly reaches a height of at least 5-10 m.

RC functions

The control modes Mode 1 or 2 (see chart RC functions) can be changed with the switch on the transmitter.
Mode 1
18
Mode 2
Throttle
Rudder
Ascend/
Descend
Aileron
Controls the propeller speed
Turn left
Descend
Left
Takeoff · RC functions
Turn right
Ascend
Right
XciteRC FunSky