Installation Example - Kessel Aqualift F Compact Directives Pour La Pose, Le Service Et La Maintenance

2.3 Installation of the air pressure switch and
the alarm sensor
Before installing the sensor clean and grease
the seating gasket. Insert the air pressure switch
into position (see illustration 5) and secure with
the red hand securing clasp. Place the optical
probe / alarm in position f (see illustration 5) in
the appropriate opening. Prior to doing this the
purple opening plug must be removed.

2.5 Installation example

➀ KESSEL Aqualift F Compact Wastewater Lifting Station
➁ Control unit with SDS (Self Diagnosis System)
➂ Outlet pressure pipe should be increase to at least size DN 70 immediately
after the outlet pipe's loop above the backwater level
➃ Ventilation to roof
➄ Inlet
➅ Connection to ventilated drainage pipe
2. Installation
2.4 Noise protection
For noise reduction the pump base as well as the
pressure outlet should be properly installed as to
prevent vibration transfer. Use the included anti
vibration matt under the Aqualift F Compact (see
illustration 5)
In case the area of installation poses a flood risk,
the Aqualift F Compact should be secured to the
floor to prevent floatation. This can be done with
the included securing brackets.
25






ill. 6