Whirlpool SPIW409/2 Mode D'emploi page 48

SAFETY PRECAUTION
4. Make sure that the power supply
cord is long enough to allow the
right connection. Do not use any
extension cord for power supply.
5. If the supply cord is damaged, it
must be replaced by the
manufacturer or its service agent
or a similarly qualified person in
order to avoid a hazard;
6. An all-pole disconnection switch
having a contact separation of at
least 3mm in all poles should be
connected in fixed wiring.
7. Risk of electric shock can cause
injury or death: Disconnect all
electric power supplies before
servicing.
8. The connection of power cord
and the cable connection
between indoor unit and
outdoor unit shall be in
accordance with the wiring
diagram attached on the
appliance.
9. Once installation is completed,
the electric components must
not be accessible to the users.
10. Use two or more people to
move and install the appliance to
avoid excessive weight hazard.
11. After unpacking the air
conditioner, keep all packaging
materials well out of the reach of
must also have a magnetic and a
thermal children.
12. According to the character of
refrigerant the pressure of the
tube is very high, so be sure to
careful when you install and
repair the appliance.
13. A residual current device(RCD)
having rated residual operation
current not exceeding 30mA
shall be incorporated in fixed
wiring according to national law.
48