Operation With A Dmx Controller - IMG STAGELINE BEAM-40/RGBW Mode D'emploi

4 Operation
The control buttons MENU, UP, DOWN and
ENTER are used to select the operating mode
and various functions (fig . 3) . The mode or the
setting will be displayed .
Button Function
To select the operating mode and
MENU
the setting options
UP
To change the setting
DOWN
To save the setting,
ENTER
to activate the function selected
Fig. 2 Functions of the control buttons
4.1 Independent operation
For independent operation, a light show pro-
gram can be activated:
1) Press the button MENU repeatedly until
or is displayed .
2) Select the program speed with the button
UP or DOWN:
= fast
= slow
Press the button ENTER to confirm .
3) For a music-controlled program, press the
button MENU repeatedly until
off) is displayed . Press the button UP or
DOWN to go to
the button ENTER to confirm .

4.2 Operation with a DMX controller

DMX stands for Digital Multiplex and means
digital control of multiple DMX units via a com-
mon control line . The functions of the channels
and the DMX values can be found in chapter
4 .2 .3 . For control via a DMX controller (e . g .
DMX-1440 or DMX-510USB), the following
numbers of DMX channels are available:
BEAM-40/ RGBW:
BEAM-40/ WS:
(Sound
(Sound on) and press
11 or 13 channels
7 or 9 channels
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
DOWN
MENU
ENTER
MENU
Fig. 3 Control menu
4.2.1 Connection
For DMX connection, 3-pole XLR connectors
with the following pin configurations are avail-
able:
Pin 1 = ground, 2 = DMX−, 3 = DMX+
For connection, special cables for DMX signal
transmission are recommended (e . g . cables of
the CDMXN series from IMG STAGELINE) . For
cable lengths exceeding 150 m and when con-
trolling more than 32 units via a single DMX
Setting of DMX mode and
UP
start address, factory-set
address: 001
Number of DMX channels
UP
BEAM-40/ WS: 7 or 9
BEAM-40/ RGBW: 11 or 13
Light show program
UP
01 = fast
02 = slow
Music control
UP
OF = off, on
Opposite pan direction of
UP
moving head
OF = no, on = yes
Opposite tilt direction of
UP
moving head
OF = no, on = yes
Display mode for upside-
UP
down installation
OF = no, on = yes
Reset to factory settings
UP
OF = no, on = yes
Reset
bold: = factory settings
9