Safety Notes; Setting Into Operation - IMG STAGELINE BEAM-40/RGBW Mode D'emploi

LED Beam Moving Head
These instructions are intended for users with
basic knowledge in DMX control . Please read
the instructions carefully prior to operation and
keep them for later reference . On page 2, you
will find the unit with all operating elements
and connections .
1 Applications / Setting Up
The unit BEAM-40 /... is used for effect light-
ing, e . g . on small stages, at parties or in clubs .
As a light source, it uses a powerful 10 W LED .
The unit is designed for operation via a DMX
light controller; however, it can also be oper-
ated independently, running an automatic or
music-controlled light show program .
Place the unit on a flat surface as desired .
Alternatively, install it upside down on a suitable
lighting support system, using the two threaded
holes (M 6) on its lower side .

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to skilled
personnel and do not insert any-
thing into the air vennts; inexpert
handling may result in electric
shock .
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C) .
•
The heat produced inside the unit must be
dissipated by air circulation; therefore, never
cover the air vents of the housing .
•
Immediately disconnect the mains plug from
the socket
1 . if the unit or the mains cable is visibly dam-
aged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
8
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For cleaning the housing, only use a dry,
soft cloth; never use water or chemicals . For
cleaning the lens, you may also use a mild
detergent .
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not safely installed or not
correctly connected or operated, or if it is not
repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .

3 Setting into Operation

WARNING
.
Please note that fast changes in lighting may
trigger epileptic seizures with photosensitive
persons or persons with epilepsy!
1) For power supply, connect the unit to a mains
socket (230 V/ 50 Hz) via the mains cable pro-
vided .
2) Switch on the light effect unit with the switch
POWER . The moving head will go to its start-
ing position .
Then the unit will go to the operating mode
most recently selected . The display will ex-
tinguish after a short while . As soon as one
of the control buttons MENU, DOWN, UP
or ENTER is pressed, the display will light up
again for a short while .
3) After operation, switch off the unit with the
switch POWER .
To prevent damage to your eyes,
never look directly into the light
source for any length of time .
(Reset) will be displayed .