Setting Into Operation; Mounting; Power Supply; Operation - IMG STAGELINE PARL- 42 SET Mode D'emploi

4

Setting into Operation

GB

4.1 Mounting

1) Place the stand on a horizontal, solid ground.
For a safe position spread the legs of the stand
as far as possible and fix them with the setscrew.
2) Place the controller with the spotlights onto the
stand tube (15) and fix it with the supplied
screws (12) from both sides.
3) To align the spotlights (14), release the respec-
tive setscrews (11, 13) and turn the spotlight into
the desired direction. Pay attention that the
cable (10) will not be stretched or squeezed.
Then retighten the screws.
On the upper side of the controller there are
additional threaded holes so that the spotlights
may also be mounted onto the controller, if
required. In this case unscrew the screw (11) of
the spotlight and fix the spotlight from above in
the same way with the screw and the rubber
washer. When changing the positions of the
spotlights, ensure that the weight is equally dis-
tributed on the left and right sides.
4) To adjust the desired operating height, first
remove the innermost tube of the stand. Place
the safety pin through the two holes for the
desired height and push in the tube to such an
extent that the safety pin is placed on the central
tube. Additionally fix the inside tube with the
setscrew.
If the desired height is not yet reached, pull
out the central tube in the same way and fix it.
IMPORTANT!
G
The stand must be set up in a stable way. Only
extract the telescopic tubes to such an extent that
a safe hold is ensured.
G
Prior to operation check all setscrews and tighten
them, if required.
G
Lay all connection cables so that nobody will trip
over them and thus may overthrow the stand.
G
Always place the unit so that during operation a
sufficient air circulation is ensured. Air vents at
the housing must not be covered in any case.

4.2 Power supply

First connect the supplied mains cable to the mains
jack (1) and then to a socket (230 V~ / 50 Hz). Then
the unit is ready for operation. To switch off, dis-
connect the mains plug from the socket.
14
WARNING To prevent damage to your eyes,
never look directly into the light
source for a long time.
Please note that fast light changes
may trigger epileptic seizures with
photosensitive persons or persons
with epilepsy!
Caution: The unit must not be connected to the
mains voltage via a dimmer!
5

Operation

The settings of the unit are made via a system
menu which can be operated by means of the but-
tons (4) and the display (3). The 4-digit display is
switched on by pressing any button and shows the
last adjustment. The display disappears a few sec-
onds after the last button has been pressed.
The buttons have the following functions:
– Button MENU / ESC to return to the superior menu
level
– Button ENTER to go to the next menu function
– Buttons UP and DOWN to select several menu
options and to adjust values
The menu structure is shown in chapter 10.2.
By means of chapter 6 or 7 make the desired
adjustments for the respective operating mode with
the buttons.
6

Operation without DMX Controller

6.1 Automatic mode

The unit has two automatic show programs (addi-
tional basic colour change programs
ter 6.4). To activate one of these programs:
1) Press the button MENU / ESC repeatedly until
the main menu is reached.
2) Select the option
button UP or DOWN.
3) Press the button ENTER: The last program
adjusted ( or
played. Select the desired program from both
programs with the button UP or DOWN.
4) To change the speed, press the button ENTER.
The present speed is displayed. Select the
desired speed from the 9 speeds
with the button UP or DOWN.
chap-
in the main menu with the
) is activated and dis-
to