Geberit FLOWFIT Mode D'emploi page 31

Maintenance
Maintenance regulations for Geberit pressing jaws
These Geberit FlowFit pressing jaws are low-maintenance and do
not need to be tested by authorised repair shops if they are used as
intended. However, pressing jaws still require maintenance.
Pressing jaws that are not maintained, or are not professionally
maintained, can cause accidents and injuries.
It is essential to observe the maintenance intervals and
maintenance work outlined below:
Maintenance
interval
Regularly, before
use, at the start of
the working day
18014405811351435 © 01-2022
969.975.00.0(01)
Maintenance work
▶
Check the Geberit FlowFit pressing jaw
for externally visible defects such as
damage, material cracks, patches of rust
and other signs of wear. Replace the
pressing jaw if defects are present.
▶
Remove any deposits on the pressing
tips.
▶
Spray the pressing tips with
BRUNOX® Turbo-Spray® and clean with
a cloth.
▶
Examine whether the jaw levers can
move easily. Check for dirt between the
jaw levers. If necessary, clean the jaw
levers and move them several times until
they are able to move easily.
EN
31