Kärcher CS 330 Bp Mode D'emploi page 34

 Position the file at the level of the top
plate.
 Pull the file along the cutting edge. An-
gle: 30 degree.
NOTICE
Only work at a 30 degree angle. At an angle
of more than 30 degree, the chain becomes
too sharp and wears faster. At an angle of
less than 30 degree the chain remains dull.
1 Flat file
2 Filing gauge
 Place the filing gauge onto the saw-
tooth.
 Refile the depth limiter with a flat file.
34
NOTICE
Filing gauges and saw chain files are avail-
able in specialist shops.
Installing the guide bar and saw chain
 Place the saw chain onto the guide bar.
NOTICE
Upon placement, ensure that the running
surface of the sawteeth is correctly placed
in the guide bar.
 Observe the rotation direction arrow
upon applying the saw chain.
NOTICE
If the saw chain was applied opposite to the
rotation direction, turn the guide bar
around. A drilled hole for the drive pin is
present at the top and bottom.
 Place the saw chain onto the chain
wheel.
 Place the guide bar onto the guide rails
and the drive pin.
 Replace cover.
 Tighten nut firmly.
– 14
EN