Electrolux GK29TCO Notice D'utilisation page 70

70 www.electrolux.com
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000).
8.5 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
stripes. The stripes must have the
same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not extend the stripes. Do not bond
ends of stripes one over another.
After you assemble the hob, seal the
remaining gap between glass ceramic
8.7 Assembly
ON-TOP INSTALLATION
min.
500mm
min.
50mm
min.
12 mm
min.
20 mm
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
8.6 Attaching the seal
1. Clean the worktop around the cut out
area.
2. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.
R 5mm
0
490 mm
+1
55 mm
0
270 mm
+1
min.
28 mm