Makita DUC204 Manuel D'instructions page 9

Saw chain type
Number of drive links
Guide bar
Sprocket
NOTICE:
When using 25AP saw chain, use with Sprocket 9 (optional accessory).
WARNING:
Use appropriate combination of the guide bar and saw chain. Otherwise personal injury may
result.
Symbols
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
Wear a helmet, goggles and ear protection.
Use appropriate protection for foot-leg and
hand-arm.
This saw is to be used by properly trained
operators only.
Do not expose to moisture.
Maximum permissible cut length
Always use two hands when operating the
chain saw.
Direction of chain travel
Saw chain oil adjustment
Only for EU countries
Ni-MH
Li-ion Do not dispose of electric equipment or battery
pack together with household waste material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Guide bar length
Cutting length
Pitch
Gauge
Type
Number of teeth
Pitch
Intended use
The tool is intended for cutting branches and pruning
trees. It is also suitable for tree service.
Noise
The typical A-weighted noise level determined accord-
ing to IEC62841-4-1:
Model DUC204
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Model DUC254
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Model DUC254C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
9 ENGLISH
25AP
60
250 mm
250 mm
1/4"
1.3 mm
Carving bar
9
1/4"
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA