Rupes FR32ES Conversion Des Instructions De Fonctionnement Original page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
the accessory towards you.
Regularly clean the fan openings of the electrical tool. The motor fan will
attract the dust into the housing; excess dust accumulation can cause electrical
hazards.
Do not operate the electrical tool in the proximity of flammable material. The
sparks can ignite these materials.
Do not use accessories that need liquid coolants. The use of water or other
liquid coolants can cause electrocution or electrical shock.
SPECIFIC SAFETY WARNINGS
Verify that no loosened part of the polishing tool shroud or the locking ties
can rotate freely. Safely position or cut all the loosened fixing wires.
Loosened or revolving fixing wires may twist around the operator's fingers
or get caught by the work piece being machined
INFORMATOIN NOISE / MEAN ACCELERATION VALUE
The tools are suppressed in accordance for the prevention and elimination of radio
disturbances measured in accordance with standard: EN 60745
Sound pressure level / Sound power level
L PA
L WA
dB(A)
FR 32ES
86
97
DANGER
The indicate measurements refer to new power tools.
Daily usa causes the noise and vibration values to change.
Displayed emission values are comparative and are to be employed for
a provisional assessment of the operator's risk exposure during the work period.
Appropriate evaluation of work period must also include tool's idle and stop
periods. These emission values represent the tool's main applications.
If the tool is used for other applications, with other accessories, or if it does not
undergo regular maintenance, emission values can significantly increase
during operations.
Use hearing protection!
3 axis vibration level
(Surface grinding)
a h
Uncertainty
Uncertainty
2
m/s
3
2,70
1,30
PARTS OF THE TOOL
1 - Technical data identification label
2 - ON/OFF switch
3 - Electronic rpm regulation
4 - Auxiliary handle
5 - Heat protection
6 - Heat protection fixing screws
7 - Wrenches
8 - Motor ventilation slots
9 - Mousse disk
10 - Spindle
STARTING UP
WARNING
Pay attention to the mains voltage! The mains voltage must
correspond to the voltage indicated on the technical data identification
label (1).
DANGER
Before any intervention on the electrical tool take the plug
out from the socket
BEFORE STARTING THE TOOL
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been damaged
during storage or transport;
- the tool is complete; check that the number and type of components comply
with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in the table
and that indicated on the tool identification plate reproduced;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch (2) works properly though with the power supply
disconnected;
- all the parts of the tool have been assembled in the proper manner and that
there are no signs of damage;
- the ventilation (8) slots are not obstructed.
ASSEMBLING THE TOOL
- Position the heat protection (5) on the gearbox such that the holes for mounting
the handle are aligned with those on the gearbox;
- screw in the auxiliary handle (4); the handle can be mounted on the left or right
of the tool body;
- if the tool is to be used without the side handle, the heat shield must be fixed in
place using the screws provided (6).
9

Publicité

Table des Matières
loading

Table des Matières