Panasonic EY6803 Instructions D'utilisation page 10

Hammer chuck (Optional accessory)
•EY9HX401
Battery pack
•EY901 (Ni-MH)
Battery charger
•EY0110
If you need any assistance for more details regarding these accessories, ask your local
service center.
VII
SPECIFICATIONS
.
MAIN UNIT (EY6803)
Concrete
Maximum drilling
diameter
Steel
Motor voltage
Speed at no load (RPM)
Blows rate per minute (BPM)
Weight (with battery pack)
Dimensions (L×W×H)
GUIDELINE TABLE
• Select the torque for fastening screws with the clutch handle.
• Guide for the selection of torque
Depending on the job, adjustments are possible in five levels by approximately 1 Nm
(10 k f-cm) increments.
g
Setting
1

Fastening
Screws 3
4
5
Drilling
Holes (Drill Mark)
(A) For fastening screws into plastic anchor which requires dia. 6.0 mm (1/4") prehole in the concrete.
(B) For directly fastening screws into concrete (like topcon) with dia. 3.5 mm (1/8") prehole.
NOTE: This is only a rough guide. Required torque is different depending on the
shape, material, and application of the screws.
Set according to the work environment of the site.
EY6803(UL).indb 10
10 mm (5/64") - 1.5 mm (15/3")*
*For work that can be completed with one battery pack.
13 mm (33/64")
1 V DC
0 - 1000 /min (rpm)
0 - 4000 /min (bpm)
.5 k (5.5 lbs)
g
49×57×64 mm (10"×10 - 1/8"× - 1/")
Torque
Approximately 1.5 Nm (15 k
Approximately .5 Nm (5 k
Approximately 3.4 Nm (35 k
Approximately 4.4 Nm (45 k
Approximately 5.4 Nm (55 k
Approximately 8.3 Nm (85 k
- 10 -
Guide Depending on Material
Concrete
(A) (B)
f-cm)
g
f-cm)
g
f-cm)
g
f-cm)
g
f-cm)
g
f-cm) Drilling holes in metal
g
Block
(A) (B)
2006/04/11 16:51:50