LUXSAR VDR1640D Guide D'installation Rapide page 17

•
To set up dome protocol and ID, press MENU to access the Main menu, and select <Camera
Setup>. The available protocols include <DynaColor>, <Pelco D>, <Pelco P>, <AD422>,
<Panasonic_C>, <Panasonic_N> and <None> (default). Note that ID number must match
the ID address defined by the dome.
•
To configure the RS-485 parameters, select <System Setup> from Main menu, and then
select <RS485 Setup>. The default
8 Data Bits, 1 Stop Bit and No Parity.
Dome Control Button:
Set/Go Toggle hint
Préset
screen
Channels
Luxsar VDR1640D DVR RS-485 settings are 9600 Baud,
Focus
Iris near Zoom
open in Menu Escap
Iris Focus Zoom
close far out
6
Enter/
Auto
Pan Jog/Shutter
Tilt