LUXSAR VDR1640D Guide D'installation Rapide page 13

Connector
Main Monitor
(S-Video / BNC /
VGA)
Call Monitor
(BNC)
Video Input
Video Looping
RS-232C
Alarm I/O & RS485
LAN 1000M
Audio In / Out
USB Connector
LAN 10/100M
(RJ-45)
Power Jack
Power Switch
Alarm I/O & RS485 Pin Definition:
Pin Definition
1 RS485 D+
2 RS485 D-
3 Ground
4 Normal Close A
5 Common Node A
6 Normal Open A
7 Ground
8 Normal Close B
9 Common Node B
10 Normal Open B
11 Ground
Description
S-Video, BNC and VGA output connectors are to be connected to the main
monitor.
The call monitor is used to display full screen video of all installed cameras in
sequence. The BNC Call Monitor connector allows the user to connect the DVR
to a call monitor.
16 BNC connectors for video input streams from installed cameras.
BNC connectors are positioned on the rear panel for looping out the video input.
The unit provides a RS-232C communication port for sending and receiving
signals.
The unit provides an alarm I/O and RS485 port that offers user the flexibility
required to connect the unit to other devices.
Used for connecting the unit to a Network-Attached Storage (NAS) device.
Audio In RCA connector for connecting an audio source device to the unit; Audio
Out RCA connector for connecting an audio output device to the unit.
Two USB 2.0 ports on the rear panel for users to connect to a USB mouse or
USB flash drive.
The DVR is capable of networking and it allows the videos to be viewed over the
LAN network or the Internet using the Internet Explorer.
Connect the power jack with the power cord which came with the shipment.
Used for powering up or shutting down the unit.
Pin Definition
12 Normal Close C
13 Common Node C
14 Normal Open C
15 Ground
16 Ground
17 Alarm In 1
18 Alarm In 2
19 Alarm In 3
20 Alarm In 4
21 Alarm In 5
22 Alarm In 6
Pin Definition
23 Alarm In 7
24 Alarm In 8
25 Alarm In 9
26 Alarm In 10
27 Alarm In 11
28 Alarm In 12
29 Alarm In 13
30 Alarm In 14
31 Alarm In 15
32 Alarm In 16
2