Network Setup - LUXSAR VDR1640D Guide D'installation Rapide

NOTE: The <Time Zone> must be set to your local time zone or the
<Network Time Protocol Setup> will not be accessible.
To Define Recording Settings:
•
Select <Record Setup> from the Main menu.
•
Select a Preset Configuration setting from <Best Quality>, <Standard> and <Extended
Record>.
•
Adjust the Recording schedule, Pre-alarm, Circular and Audio parameters.
•
When the settings are complete, press ENTER to confirm and save the settings; or ESC to
abort.
To Select Viewing Mode:
•
Press MODE button repeatedly to select the wanted display mode. The available viewing
modes are full-screen, 2×2 and 4×4 split-window.

Network Setup

Using LAN / Cable Modem:
Use the LAN setup when you plan to use a LAN, WAN, or Internet connection without a dialup
modem. It requires an Ethernet connection to a network. The default ID of your
DVR must be changed to avoid network conflicts.
•
From Main menu, select <System Setup> <Network Setup>, set the <LAN Select> item to
<LAN> or <PPPoE> according to your network application, and enter <LAN Setup>.
•
For DHCP user, set the DHCP to <ON>. The IP address, Netmask, Gateway and DNS
settings are retrieved from network servers. DHCP is dynamic; the settings will change from
time to time.
•
For Non-DHCP user, set the DHCP to <OFF>. You must enter an IP address, Netmask,
Gateway and DNS settings. Please obtain these settings from your network service provider.
•
To change the IP address, Netmask, Gateway and DNS value, press UP/DOWN keys to move
the cursor to the item. Use LEFT/RIGHT keys to access each section of the value and press
ENTER, then change the value using UP/DOWN keys.
•
PPPoE users must set the <PPPoE Account>, <PPPoE Password> and <PPPoE Max Idle>
as well.
•
When the settings are complete, press ENTER to confirm and save the settings, or ESC to
abort.
4
Luxsar VDR1640D