Please read all instructions carefully before assembly, installation and/or use of this product.
1
2
Rubber Washer
Screw, #10-32 (Self Tapping)
ATTACH AIR DEFLECTOR
•
Line up the holes in air deflector with the four holes in the front cross tubes of cargo carrier basket. Install four #10 self-
tapping screws with rubber washers as shown. Tighten screws until the rubber washers start to compress – DO NOT
OVER TIGHTEN!
3
Cequent Consumer Products Inc
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
Product Name:
cross bars
Roof Top Carrier
Product Code:
59504
ASSEMBLE CARGO CARRIER
•
To assemble the cargo carrier basket,
place the two halves of basket on a flat
non-marring surface. Insert the two
locators on each half of basket so the
locator is fully engaged, both sides.
•
Install the four (4) self-tapping screws into
the existing holes on the inside of basket,
two (2) per side as shown.
POSITION CROSS BARS
•
Adjust your cross bars to one of (4) four
available settings:
•
37-1/2" center to center
•
33-3/4" center to center
•
30" center to center
•
26-1/4" center to center – Minimum
•
NOTE: It is recommended to use the
widest setting for optimum load
distribution.
•
Leave cross bars loose at this step.
www.rolaproducts.com
Page 2
59504N Rev A 4-8-05