Rola 59854 Mode D'emploi

Part Description
A Button head bolt M5 x 20mm
B Nylon washer
C Plus Nut Insert M5
D Hex bolt M5 x 30mm
E Hex Nut M6
F Washer M5
G Star Washer M5
H 3mm (.125") Drill Bit
I .290 Dia. ("L") Drill bit
J Hex Key- 3mm
K Silicone sealant
L Track and Isolator pad
M Track End Cap- closed (Front)
N Track End Cap- open (Rear)
Tools required to install
A
F
C
G
B D E
Precaution Warnings before beginning
Use of ROLA track systems with Plus Nuts is intended for sheet
metal installations.
Install requires drilling and permanent installation of tracks.
Installation requires some tools and skill. If concerned please
have professionally installed.
Placement of Track Rails onto Vehicle surface (Crew Cab Truck shown)
Align Tracks parallel to each other and equal distance
from rear.
Hint: pre-installing your ROLA cross bars on the tracks
will insure good placement.
59854N Rev B 4-15-13
Direct Mount Track Rail System TR54
For use on sheet metal surfaces
For use with ROLA APE and APX cross bar kits
H
I
Qty
12
12
12
1
1
A
1
B
12
C
1
1
1
1
2
2
2
Tools required:
A Masking tape
B Fine tip marker
C Center punch C Center punch
D 8mm wrench
E 10mm wrench
Caution- never exceed the load rating for your
vehicle (contact manufacturer for details), or that
of your cross bar system which ever is lower.
Using a fine tip marker mark every other hole in track. Insure to mark the
holes on each end of the tracks.
DO NOT mark or drill every hole as it is not required.
Hint: Use masking tape to hold the tracks well in place while marking.
Isolator pad can be removed while marking.
Then use a center punch to set the drill position.
Printed in China
PART No.
K
D
E
I
F
G
H
J
L
F Tape measure
G Hammer
H H Drill motor Drill motor
I Safety glasses
Mark every other hole in track
59854
M
N
Page 1 of 2