REDCAT TORNADO EPX PRO Guide Rapide page 18

ESC
RCR-2CENR RADIO SYSTEM
Programming (Continued)
Press and release
The Red LED
the SET button
flashes. The
once the desired
number of
number of Red
flashes indicates
flashes is
the program
reached.
option on the
chart.
Programming Flow Chart
Turn OFF the ESC,
Turn ON the transmitter
Hold the SET key,
Switch ON the ESC
Red LED flashes
Green LED flashes
1 time
Hold SET key for 3 more seconds
Green LED flashes
2 times
Hold SET key for 3 more seconds
Green LED flashes
3 times
Hold SET key for 3 more seconds
The following steps are just like the above steps...........
Hold SET key for 3 more seconds
Green LED flashes
N times
Turn off
the ESC.
Enter the corresponding
programmable item, the RED
LED flashes the current # value
of this item
Enter the 1st item
"Running Mode"
Release
SET key
Enter the 2nd item
"Drag Brake Force"
Release
SET key
Enter the 3rd item
Release "Low Voltage Cut-Off"
SET key
Enter the Nth item
Release
SET key
5. The Red LED will flash the number of times that corresponds to the number of the
option listed along the top of the chart. (1 flash = Option 1, 2 flashes = Option 2, etc.)
6. Press and release the set button until the desired number of Red flashes is achieved.
7. To finish set up, turn OFF the ESC.
8. You can now power the ESC back on. The settings should now be saved.
9. Repeat steps 1-8 for each setting you wish to adjust.
Press SET key to choose the programmable value,
the RED LED flashes the # of the value you are
choosing. (1 flash = the 1st value, 2 flashes = the 2nd
value....)
Red LED flashes 1 time to choose
"Forward with Brake"
Red LED flashes 2 times to choose
Press
SET key
"Forward/Reverse with Brake"
Red LED flashes 1 time to choose 0%
Red LED flashes 2 times to choose 5%
Red LED flashes 3 times to choose 10%
Red LED flashes 4 times to choose 15%
Press
SET key
Red LED flashes 5 times to choose 20%
Red LED flashes 6 times to choose 25%
Red LED flashes 7 times to choose 30%
Red LED flashes 8 times to choose 40%
Red LED flashes 1 time to choose "None"
Red LED flashes 2 times to choose "2.6V"
Press
Red LED flashes 3 times to choose "2.8V"
SET key
Red LED flashes 4 times to choose "3.0V"
Red LED flashes 5 times to choose "3.2V"
Red LED flashes 6 times to choose "3.4V"
Press SET key to choose the value, the # of RED
LED flashes means the # of the value (1 flash =
the 1st value, 2 flashes = the 2nd value....)
Press
SET key
TM
17 17