Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ESC GUIDE
ESC
RCR-2CENR RADIO SYSTEM
FEATURES:
Splash-proof and dust-proof.
(Remove the cooling fan when running in wet conditions. If the ESC gets wet, clean and dry thoroughly to avoid damage from the
oxidation of copper connectors). The ESC CANNOT be submerged.
External Programming Port (EPP), can be used to connect a program card, and also doubles as the power port for the cooling fan.
Smooth start-up, acceleration and linearity features.
The powerful built-in switching mode BEC provides reliable power to servos and electronics.
Mounting stand allows for easy and secure mounting of the ESC to the chassis.
Proportional braking function with 4 steps of maximum brake force adjustment and 8 steps of drag-brake force adjustment. Also
compatible with a mechanical disc-brake system.
Multiple protective features: Low voltage cut-off protection / Over-heat protection / Throttle signal loss protection / Motor overload
protection.
WARNING:
To avoid short circuits, ensure that all wires & connections are well insulated and there is proper contact at all connections. Read through
the entire manual before operating and ensure all electronics are installed correctly. To avoid accidents, we recommend setting the
vehicle on a stand, with the tires free from any contact, while connecting and adjusting electronics. While the vehicle is on the stand,
never pull the throttle trigger to its full position. Doing so can cause the tires to balloon and tear, which may result in injury and/or
damage. Stop usage and unplug the battery immediately if the ESC exceeds 90ºC/194ºF as this may damage both the ESC and motor.
Disconnect the battery after use. The ESC continuously draws current from the battery (even if the ESC is turned off). If left plugged in
for long periods of time, the battery will completely discharge, which may result in damage to the battery or ESC. This WILL NOT be
covered under warranty.
Specs:
Model:
WP-10BL60-RTR
Cont. / Peak Current:
60A / 390A
NiMH / LIPO Cells:
4-9Cells NiMH， 2-3S LiPo
Applications:
1/10 Car, Truggy, Buggy, Monster Truck
Built in BEC:
6V / 3A, Switch mode
Size / Weight:
48.5mm × 38mm× 32mm / 90g
Programming Port:
FAN / PRG Port
Motor Type:
Sensorless Brushless Motor
2S LiPo, 4-6 cell NiCD/NiMH 4500KV
Motor Limit:
3S LiPo, 7-9 cell NiCD/NiMH 3500KV
Slash-proof:
Cannot Be Submerged
NOTE: The cooling fan is powered by the built-in BEC, so it is always working under 6V .
TM
15 15
Publicité
Table des Matières
