Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ESC
RCR-2CENR RADIO SYSTEM
Calibration
Press and hold the
Turn ON the ESC
SET button
Move the throttle trigger
The Green
to the neutral position and
LED flashes
press the SET button.
once and
motor emits
"Beep"
tone.
3. To set the neutral point, leave the throttle trigger at the neutral position, press the SET button. The RED LED dies out and the GREEN LED flashes 1
time and the motor beeps 1 time to accept the neutral position.
4. To set the full throttle endpoint, pull and hold the throttle trigger to the full throttle position and press the SET button. The GREEN LED blinks 2 times
and the motor beeps 2 times to accept the full throttle endpoint, then release the trigger.
5. To set the full brake endpoint, push and hold the throttle trigger to the full brake position, press the SET button. The GREEN LED blinks 3 times and
the motor beeps 3 times to accept the full brake endpoint. Release the trigger back to the neutral point. (The motor can be started 3 seconds after
the ESC/Radio calibration is complete)
Programming
Press and hold
Turn ON the ESC
the SET
button
Programmable
Items
1. Running Mode
2. Drag Brake Force
3. Low Voltage
No Protection
Cut-Off Threshold
4. Start Mode(Punch)
Level 1 (soft)
5. Max Brake Force
NOTE: The shaded boxes are default settings
Release the
SET button
once the LED
flashes.
Pull the throttle trigger
to the end position of
forward and press the
SET button.
The Red
LED
flashes
The Green
LED flashes.
1
2
Forward
Forward/Reverse
with Brake
with Brake
0%
5%
2.6V/Cell
Level 2
25%
50%
1. Turn on the transmitter, set parameters on the throttle channel like
"D/R", "EPA" and "ATL" to 100% and the throttle "TRIM" to "0". Disable
the "ABS braking function", if available on your radio.
2. Start with the transmitter on and the ESC turned off but connected to
a battery. While holding the SET button, Turn ON the ESC, then release
the SET button when you see the RED LED on the ESC start to flash.
(Note: the motor beeps at the same time) (The ESC will enter the
programming mode if the SET button is not released within 3 seconds,
which will then require you to restart from step 1.)
The Green
LED flashes
twice and
motor emits
"Beep-Beep"
tone.
1. Turn on the transmitter.
2. Press and hold the set button on the ESC ON/OFF switch.
3. Turn ON the ESC.
4. Continue to hold the set button until the Green LED flashes the
number of times that corresponds with the item # you wish to
adjust. Refer to the "Item #" column of the chart to determine the
number of Green LED flashes needed.
(1 flash = Running Mode, 2 flashes = Drag Brake Force, etc.)
Programmable Value
3
4
10%
15%
2.8V/Cell
3.0V/Cell
Level 3
Level 4 (Aggressive)
75%
100%
TM
16
16
Battery
Push the throttle trigger
The Green LED
to the end position of
flashes three
reverse and press the
times and
SET button.
motor emits
"Beep-Beep-
Beep" tone.
5
6
20%
25%
3.2V/
3.4V/
Cell
Cell
7
8
30%
40%
Publicité
Table des Matières
