External Remote [0 - 10V] Connection; Maintenance; Troubleshooting; Error Message - ELC ALR3206T Manuel De Prise En Main Rapide

Triple alimentation courant continu programmable 2 x 0 - 32 v ; 2 x 0 - 6 a, 1 - 15 v ; 3 a ; 15 w
Masquer les pouces Voir aussi pour ALR3206T:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11 EXTERNAL REMOTE [0 – 10V] CONNECTION
This function changes the voltage setpoints for channels 1 and 2 or voltage / current for
channel 1 via an analogical voltage, a potentiometer or resistance.
The maximum setpoint value is the one displayed before activating the function
Follow sequence configuration :

12 MAINTENANCE

No particular maintenance is required for this instrument.
Avoid : dust, humidity, shocks ; your instrument will appreciate it.
For the cleaning, please use a smooth duster.
12.1

TROUBLESHOOTING

If indicators do not light up on switching on, check :
- The connection to mains
- The replacement of the cord can be realized only with the model :
2
3G 0.75mm
; H05VV-F; CEE7/7 - IEC60320 C13
- The mains voltage
- That the ON/OFF switch is pressed

12.2 ERROR MESSAGE

If following messages appear on the display, please contact the after sales service.
Message
"FAULT : FAILURE START-UP VOLTAGE"
"TEMPERATURE SENSOR ERROR"
"UNREGULATED CURRENT/VOLTAGE
PROTECTION"
"FAN OUT OFF ORDER"

13 AFTER SALES SERVICE

The after sales Service is ensured by the elc company.
During two years, spare parts and workmanship are guaranteed. This guarantee does not
apply to instruments presenting defects or faults caused by an improper use (wrong mains
voltage, shocks ...) or which have been repaired outside our factory or the repair shops of our
authorized agencies.
4000 4 361_09/22
Follow and valid choices with key
Resistor mode
(Configuration
POTENTIOMETER)
A N A L O G R E M O T E
I N 2
I N 1
C o m m a n d e
C o m m a n d e
C H 2 ( V )
C H 1 ( V / A )
o u C H 1 ( A )
28
Potentiometer mode
(Configuration
POTENTIOMETER)
A N A L O G R E M O T E
I N 2
I N 1
C o m m a n d e
C o m m a n d e
C H 2 ( V )
C H 1 ( V / A )
o u C H 1 ( A )
Possible cause
Internal auxiliary power doesn't work
Internal temperature sensor doesn't work
Internal stage power doesn't work
Fan doesn't work
Voltage control mode
(Configuration
VOLTAGE)
A N A L O G R E M O T E
I N 2
I N 1
0 - 1 0 V
0 - 1 0 V
C o m m a n d e
C o m m a n d e
C H 2 ( V )
C H 1 ( V / A )
o u C H 1 ( A )
ENGLISH

Publicité

Table des Matières
loading

Table des Matières