Rothenberger RO RH4000 Instructions D'utilisation page 26

The operating display (3) lights up continuously.
Fault:
● Warning display (4) lights up continuously.
Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 ° C and 50 ° C, the charging process begins automatically.
● Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
The battery pack was not pushed correctly onto the sliding seat (2).
5 Care and Maintenance
RO RH4000:
The vent slots of the machine should be cleaned periodically.
Charger:
Repairs to the charger must only be carried out by qualified electricians.
If the mains connection cable of this tool is damaged, in order to prevent endangering personnel
and property it must be replaced by the manufacturer, or the Customer Service of the manufac-
turer, or a similarly qualified person.
6 Accessories
Accessory Name
Hammer drill SDS Plus, 5x110mm
Hammer drill SDS Plus, 6x110mm
Hammer drill SDS Plus, 6x160mm
Hammer drill SDS Plus, 8x110mm
Hammer drill SDS Plus, 8x160mm
Hammer drill SDS Plus, 10x160mm
7 Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using RoService+ online:
Phone: + 49 (0) 61 95 / 800 – 8200
Fax: + 49 (0) 61 95 / 800 – 7491
Email: service@rothenberger.com
www.rothenberger.com
22
ROTHENBERGER Part Number
111401
111405
111406
111411
111412
111419
www.rothenberger.com
ENGLISH