Rothenberger RO RH4000 Instructions D'utilisation page 22

Do not touch or short-circuit battery packs!
Slightly acidic, flammable fluid may leak from defective
Li-ion battery packs!
If battery fluid leaks out and comes into contact with
your skin, rinse immediately with plenty of water. If bat-
tery fluid leaks out and comes into contact with your
eyes, wash them with clean water and seek medical
attention immediately!
Transporting li-ion battery packs: The contained lithium-ion batteries are subject to the Dan-
gerous Goods Legislation requirements. The user can transport the batteries by road without fur-
ther requirements. When being transported by third parties (e.g.: air transport or forwarding
agency), special requirements on packaging and labelling must be observed. For preparation of
the item being shipped, consulting an expert for hazardous material is required. Only send the
battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-circuiting (e.g. by protecting them with ad-
hesive tape).
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
2 Technical Data RO RH4000
RO RH4000 without battery, art.-no.: 1300003382
Voltage of battery pack ............................................................... 18V
No-load speed ............................................................................... 0 - 1100 min
Maximum drill diameter
Maximum impact rate .................................................................... 4000 min (bpm)
Single impact force (EPTA (05/2009) ............................................. 2,2 J
Single impact performance ............................................................ 164 J (s)
Maximum drill diameter
Maximum drill diameter
Weight with smallest battery pack .................................................. 2,9 kg (6,4 lbs)
Collar diameter .............................................................................. 43 mm (1 11/16 in)
Sound pressure level (L
Acoustic power level (L
The noise level during operation can exceed 80 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 60745.
Vibration total value (vector sum of three directions):
Vibration emission value, hammer drilling into concrete (a
Vibration emission value, chiselling (a
The vibration level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may
be used for a preliminary assessment of exposure.
18
............................................................ 24 mm (15/16 in)
............................................................. 25 mm (1 in)
............................................................. 13 mm (½ in)
) ............................................................. 87 dB (A) ¦ K
pA
) ............................................................. 98 dB (A) ¦ K
WA
) ................................... 15,0 m/s² ¦ K
h,Cheq
ENGLISH
-1
pA
WA
) ...... 13,7 m/s² ¦ K
h,HD h,HD
h,Cheq
(rpm)
3 dB (A)
3 dB (A)
1,5 m/s²
1,5 m/s²