Display Elements; Labeling - Balluff BNI PNT-508-055-P067 Notice D'utilisation

BNI PNT-508-055-P067 / BNI PNT-538-055-P067
Network interface
4
Product description (continued)
4.3

Display elements

Fig. 4-3: Display elements
Port/Pin LEDs Standard-Port
Display Meaning
Off State of input or output pin is 0
Yellow State of input or output pin is 1
Both LEDs Short circuit of sensor supply between
flashing red pin 1 and pin 3
Red Short circuit at output on pin 2/4 against
pin 3
Red No high signal at diagnostic input
Tab. 4-1: LEDs Standard-Port
Port/Pin-LEDs IO-Link-Port
Display Meaning
Green IO-Link connection active
Flashing No IO-Link connection or incorrect
green IO-Link device
Green, fast IO-Link: Preoperate during data storage
flashing
Red, fast Validation failed / incorrect configuration
flashing of the IO-Link data length
Red, fast Data storage failed / incorrect device for
flashing data storage
Red IO-Link: Short circuit of pin 4 against
pin 3
Tab. 4-2: LEDs IO-Link-Port
8 english
Status-LEDs
LED
US
UA
Status-LEDs:
Module status
Port/Pin-LEDs: SF
Status of IO-Link
and I/O-Ports
BF
MS
100
XF1/2 Green
Tab. 4-3:
4.4
Fig. 4-4:
Display Meaning
Green Input voltage OK
Red flashing Input voltage low (< 18 V)
Green Output voltage OK
Red flashing Output voltage low (< 18 V)
Red No output voltage present
(< 11 V)
Off No error
Red Watchdog timeout; channel,
general or extended diagnostics
present; system error
Red flashing Service DCP signal started via
bus
Off No error
Red Low speed of physical link; or no
physical link
Red flashing No data exchange or no
configuration
Green No error
Blue flashing Ping command
Blue Limit exceeded by internal
counter (e.g. operating hours)
Yellow, Sensor supply below 18 V
flashing
Actuator supply below 18 V
No sensor supply 0 V
No actuator supply 0 V
Temperature too low
Temperature too high
Red Internal failure
Off Transmission rate: 10 Mbit/s
Yellow Transmission rate: 100 Mbit/s
Data transfer
Status-LEDs

Labeling

Order code Type
Labeling (example)