User Instructions For This Guide; Other Applicable Documents; Symbols And Conventions; Explanation Of The Warnings - Balluff BNI PNT-508-055-P067 Notice D'utilisation

BNI PNT-508-055-P067 / BNI PNT-538-055-P067
Network interface
1

User instructions for this guide

1.1 Validity
This guide provides all necessary information for the safe
use of the following Profinet IO-Link masters:
– BNI PNT-508-055-P067
Order code: BNI00EK
– BNI PNT-538-055-P067
Order code: BNI00F8
Read this guide and the other applicable documents
completely before installing and operating the product.
Original User's Guide
This guide was created in German. Other language
versions are translations of this guide.
© Copyright 2021, Balluff GmbH
All content is protected by copyright. All rights reserved,
including the right to reproduce, publish, edit and translate
this document.
1.2

Other applicable documents

Additional information about this product can be found at
www.balluff.com on the product page, e.g. in the
following documents:
– Data sheet
– Declaration of Conformity
– Disposal
1.3

Symbols and conventions

Individual action instructions are indicated by a preceding
triangle.
► Instruction 1
Action sequences are numbered consecutively:
1. Instruction 1
2. Instruction 2
Numbers unless otherwise indicated are decimals
(e.g. 23). Hexadecimal numbers are represented with a
preceding 0x (e.g. 0x12AB).
Buttons or selectable menu entries are described in italic
and small caps, e.g. S .
ave
Menu commands are joined with a greater-than sign,
e.g. "S > O " stands for the menu command
ettingS ptiOnS
Options from the Settings menu.
Note, tip
This symbol indicates general notes.
4 english
1.4

Explanation of the warnings

Always observe the warnings in these instructions and the
measures described to avoid hazards.
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
► Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a danger that could lead to damage to or
destruction of the product.
DANGER
The general warning symbol in conjunction with the
signal word DANGER identifies a hazard which, if not
avoided, will certainly result in death or serious
injuries.
1.5

Technical terms and abbreviations used

FE Function ground
GND Electrical ground, 0 V
I/O Standard inputs and outputs
IOL IO-Link
ISDU IO-Link-Parameter (Index Service Data Unit)
n.a. Not available
UA Actuator supply
US Sensor supply
N24 Separate power supply (−)
MS Module status
P24 Separate power supply (+)
PNT ProfiNet
TM
1.6

Pictures

Product views and pictures in these operating instructions
may differ from the specified product.