Anti-Splinter Insert - Bosch JS572E Consignes De Fonctionnement/Sécurité

Masquer les pouces Voir aussi pour JS572E:

Consignes d'utilisation/de sécurité (56 pages)

Table Des Matières

Table des Matières

Les langues disponibles

BM 2609932920 10-13_BM 2609932920 09-13.qxp 10/9/13 9:35 AM Page 9

For vacuuming, a Bosch Air Sweep vacuum

hose or hose adapter (sold separately) can be

directly connected to the extraction tube

(Fig. 5).

The VAC024 adapter allows connection to

1-1/4" and 1-1/2" vacuum hoses.

EXTR CTION

TUBE

(Not included,

sold separately)

V C024 D PTER

(Not included, sold separately)

ATTACHING STEEL OVERSHOE

Your tool is equipped with a protective plastic

overshoe that protects finer surfaces. An

PLUNGER SPEED

The jigsaw cutting speed or stroke rate

required depends on the material being cut,

the type of blade being used, and the feed rate

preferred by the operator.

The best speed for a particular application is

largely determined by experience though as a

general rule, slower speeds are for denser

materials and faster speeds for softer materials.

Note: that when the jigsaw is used at low

speed settings for an extended length of time,

the motor temperature will rise due to slower

speeds of the internal cooling fan. In such

cases, it is necessary to occasionally run the

tool at full speed for a few minutes to keep the

motor running at high efficiency.

optional heavy-duty steel overshoe for work in

rough conditions is sold separately.

To attach, slide overshoe in direction of arrow

completely onto metal footplate (Fig. 6).

FIG. 6

To minimize splintering of the top surface of

FIG. 5

the material being cut, place the anti-splinter

insert in the blade opening of the footplate's

plastic overshoe (Fig. 7).

Note: The anti-splinter insert cannot be used

when the footplate is tilted for angle cutting.

Note: This insert will only work with blades that

have ground sides such as T301CD, T101B,

T101D, and T101DP.

FIG. 7

V CUUM HOSE

NTI-SPLINTER

(Not included,

sold separately)

Operating Instructions

Your Jigsaw is equipped with a variable speed

dial. The blade stroke rate may be adjusted

during cutting operation by presetting the dial

on or between any one of the six numbers (Fig. 5).

Setting

-9-