Bosch JS572E Consignes De Fonctionnement/Sécurité page 8

BM 2609932920 10-13_BM 2609932920 09-13.qxp 10/9/13 9:35 AM Page 8
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with a Bosch tool-less
blade changing system for fast and easy
changes of T-shank blades.
Note: This jigsaw does not accept U-shank
blades.
If blade is not properly
W RNING
installed, then the blade may
unexpectedly dislodge from jigsaw when tool is
energized.
1. To remove a previously-used blade, pull
blade change lever until blade ejects (Fig. 2).
Blade ejects forcefully when
W RNING
released. Direct away from
yourself or bystanders.
2. Pull the blade change lever to the point that
the notch on the blade clamp's ring line up with
the slot in the center of the clamp (Fig. 2).
DOUBLE ROLLER
GUIDE
BL DE
FIG. 2
DUST EXTRACTION
(Not included, sold separately)
The JA1012 Dust Extraction Kit includes a dust
shroud and an extraction tube for connecting
the jigsaw to a vacuum hose or vacuum hose
adapter.
Note: The dust shroud must be used when the
extraction tube is connected to a vacuum
cleaner system.
Assembly
3. Insert the saw blade (teeth in cutting
direction) until it the "T" part of the blade shank
is completely inserted in to the blade clamp.
(When inserting the saw blade, the back of the
blade must rest in the grooves in double roller
guide Fig. 3.)
4. When blade change lever is released, it will
spring back to its closed position.
5. Verify that the blade clamp has also
returned to its closed position (which is the
point where slots were previously).
Note: If the saw blade cannot be inserted into
the plunger, the slots of the blade holder are
not in the correct position.
The double roller guidance system helps to
ensure minimal blade deflection.
BL DE
CH NGE
LEVER
NOTCH
SLOT
BL DE
CL MP RING
To use this feature, insert extraction tube into
footplate. (Fig. 4).
FIG. 4
-8-
PRECISION CONTROL
FIG. 3
BL DE
DUST SHROUD
(Not included,
sold separately)
BL DE CH NGE
LEVER