Bosch JS572E Consignes De Fonctionnement/Sécurité page 10

BM 2609932920 10-13_BM 2609932920 09-13.qxp 10/9/13 9:35 AM Page 10
SLIDE ON-OFF SWITCH
(Model JS572EB only)
The tool is switched "ON" by the switch button
located at the side of the motor housing. The
switch locks in the "ON" position, a
convenience for continuous operation (Fig. 1).
TO TURN THE TOOL "ON" slide the switch
button forward.
TO UNLOCK THE SWITCH, slide the switch
button backward.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
(Model JS572E only)
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed
can be adjusted from the minimum to maximum
SPM as set on the variable speed dial by the
pressure you apply to the trigger. Apply more
pressure to increase the speed and release
pressure to decrease speed.
Regardless of the pressure applied on the
trigger, the tool will not operate any faster than
maximum speed setting selected on the
variable speed dial.
"LOCK-ON" BUTTON (Model JS572E only)
The "Lock-ON" button, located in the handle of
your tool allows for continuous operation at
maximum preset SPM without holding the
trigger (Fig. 1).
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
If the "Lock-ON" button is
W RNING
continuously being depressed,
the trigger can not be released.
WORK LIGHT
Your tool is equipped with a work light for better
visibility during operation. The tool power cord
must be plugged into a power source before
you activate the light. To turn light ON depress
the work light ON/OFF switch. To turn light off
depress the ON/OFF switch again (Fig. 1).
CONSTANT RESPONSE CIRCUITRy
The internal electronic feedback system
provides a "soft start", which will reduce the
stresses that occur from a high torque start.
The system also maintains the selected
speed under load for maximum efficiency.
BLADE ORBIT SELECTOR LEVER
Maximum cutting efficiency can be obtained
by adjusting the blade orbit selector lever to
suit the material being cut.
The following chart will help you determine
which setting to use for your application. This
chart is intended as a guideline only, and test
cuts in scrap material should be performed
first to determine the best setting.
Setting O
blades, rasp work and down cutting blades.
Setting I
Setting II
Setting III
clean cut.
CHIP BLOWER
Your jigsaw is equipped with a two position
chip blower to help keep the cutting line clear
of chips.
By adjusting the chip blower lever the force
of the discharge air may be altered as
follows;
BLOWER SWITCHED ON
For working with wood,
plastic and similar materials
that produce large amounts
of sawdust.
BLOWER SWITCHED OFF
For working with metals
and when cooling agents
are used, or with dust
collection accessory.
-10-
Hard materials such as
metals or thin sheet
metals. This setting can
be used with knife
blades, grit edge
Soft materials where
cleaner cutting or
delicate scrolling work is
performed.
Medium density
materials such as
harder woods or
particle board.
Soft materials such as
wood, plastics, etc. and
when fast cutting is
more important than a