Tornado TV2 SS Manuel De Fonctionnement Et D'entretien page 6

The power supply cord plus any extension
leads should not exceed 100 ft. (30 m) in total,
otherwise you may experience problems
starting up the machine. The cross-section of
any extension cable wiring must be at least
AWG 13 (2,5 mm²).
Should an extension cord be used, ensure cord
rating is adequate for the equipment. Do not
use extension cord in coiled condition as this
could result in overheating of the cord.
IMPORTANT - If the supply cord is
damaged, it must only be replaced by a special
cord available from the manufacturer or an
authorised service agent.
Symbols & Markings
How to assemble the vacuum
WARNING - Before undertaking
assembly or changing of accessories/
tools switch off machine and unplug from
the electricity supply.
• Insert the hose into the socket on the front of
the vacuum cleaner (Fig 1).
• Twist in a clockwise direction until locked into
position.
Fitting the handle, wand and floor tool
• Fit the handle to the wand connection (Fig 2).
WARNING
Fig 1
Fig 2
• Fit the wand to the floor tool (Fig 3)
Controls
• The on off switch is positioned at the rear of
the machine (Fig 4).
• To turn the machine on press the button.
• To switch off the machine press the button
again
* When operating the unit in a noise sensitive
area, the unit may be adjusted with the knob on
the right rear of the unit (Fig 4). This will also
decrease the suction power.
Operation
Starting the machine
• Ensure cable is fully extended before use.
• Ensure a dust bag is fitted before use.
• Press the on/off button to turn the vacuum
cleaner on.
• Suction can be adjusted by sliding the airflow
adjuster located on the hose handle (Fig 5).
6
Fig 3
Fig 4
Fig 5