Input Selection - Sanyo CE42WPX1 Manuel D'utilisation

GB
Step : 1 Mains Connection
■
Connect the display unit to Aerial, VGA, HDMI and Scart
connectors as required.
1. Connect the inline power connector to the connector attached to
the rear of the LCD monitor as shown above.
2. Connect the power cord of the LCD monitor to a wall outlet.
✐
As this product does not have a mains On/Off switch, please
ensure your mains plug is easily accessible.
✐
The LCD monitor is prepared for a mains voltage AC220~240V,
50Hz. To completely switch off the mains, or when the LCD
monitor is not to be used for an extended period of time, it is
advisable to disconnect the power cord from the power outlet or
disconnect the mains lead.
✐
Please use the correct mains lead supplied with the set for your
area.
3.
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
Step : 2 Connections

■ INPUT selection

To switch between TV, AV1,RGB, AV2, HDMI or PC mode press the
TV/ AV button on your remote control repeatedly or press and hold the
TV/AV button for a few seconds and a selection menu will appear on
screen. Use the 5 or 6 buttons to select the correct input.
1.HDMI (High Definition Multimedia Interface)
This monitor has an HDMI connector. Connect to the HDMI source
and select HDMI using the remote control.This input will suport a
large range of resolutions as shown on page 13.
This connection is located at the back of the monitor set.
4
INST ALLA TION
INST ALLA TION
2. AV1 / AV2
You can connect your DVD player or other scart connected equipment
to the AV1 and AV2 scart connection terminals at the rear of the
monitor as required.
3. PC connection
This LCD monitor has a PC connector (PC-IN D-SUB)
You can connect a PC to the LCD monitor and use it as a monitor
display (see page 9). This input will support a large range of
resolutions as shown on page 13.
4. External Audio Output
To output the audio signal from AV 1,2, PC and HDMI. The speaker
impedance should be 8 ohms.
5. Use of Monitor Audio Output Connections
The audio monitor out socket on the rear of the set provide a fixed
level audio output for reproducing sound via your audio equipment.
GB