Reer 5006 SCOPI Manuel De L'utilisateur page 21

Prepare As Baby Monitor
It only takes one simple programming step after inserting and charging the battery
pack to determine which unit will serve as the baby unit and which one as the parent
unit.
•
Turn one unit on (press the On/Off button
•
Press the MENU button twice.
The display shows the baby icon
•
Press
parents).
•
Briefly press the PTT button to confirm, or simply wait a few seconds.
The babysitter setup is completed.
Now the display shows the baby or parent channel top left, such as
bottom center.
This setting already includes the highest sensitivity setting for the baby unit, automatic
out-of-range control between baby and parent unit, the possibility to test the range and to talk to
the baby.
What Else Can Be Set?
Volume
•
Press
The display shows the volume setting in steps between LE 00 and LE 09.
The volume setting is important in case you want to talk to the baby. Set the volume level to LE
00 to mute the baby unit at all times.
Set the volume level for the parent unit to the desired level.
Display Alarm
The parent unit with muted speaker (set to LE 00) still lights up to show that the baby unit is
communicating.
•
The display backlight turns on for approximately 5 seconds with every alarm.
and
on the baby unit to select
to set the volume.
for 3 sec).
OF
.
b
(on the other unit select
5
P
(=
b1
and the baby icon