Installation Instructions; General Instructions; Preparation - WANDERS Domus Mode D'emploi Et Instructions D'installation

Installation Instructions

General instructions

Preparation

Fire Safety
Installation
Repairs
Technical details Domus / Luna Petite
General instructions
The Domus and the Luna Petite are tested in accordance
with international EN13240 standardisation and have
extra additional standardization for optimal environment-
friendly heating devices related to flue gases (Section
15a B-Vg. Des BmfWA).
The stove can be connected to a flue tube to which
several stoves are connected. The shove should never be
integrated into the wall. The stove must be installed by
an acknowledged installer lest the guarantee lapses
The heating device must be placed by an acknowledged
installer and according to the installation instructions
given below. The national and local rules and regulations
for placing and using wood-burning stoves are equally
applicable. WANDERS does not give any guarantee
if the stove is connected or installed incompletely or
incorrectly.
It is not allowed to place the stove in:
• Arcades and corridors accessible to the public.
• Stairwells, except in buildings with no more than 2
dwellings.
• Spaces where highly flammable or explosive materials
are used.
• Spaces where an exhaust system is used or where a
mechanical exhaust system is placed, except when
the air supply is taken directly from outside to assure
a hazardless combustion.
Preparation
The chimney flue
Before placing the stove you must observe the following
points:
• If the stove is connected to an existing chimney, you
must first have the chimney professionally cleaned
and checked by a qualified chimney sweep company.
Any cut-off valves or stop valves must be removed.
• The flue tube of the stove must be connected with the
chimney without diversions.
• The underpressure in the chimney must be at least 12
20
20
20
21
21
22
23
Pa or 0.12 mbar.
• The chimney flue must always end up in outlet area 1
(see the drawing and the table below)
Roof slope x larger than 23°
Roof slope x smaller than 23°
• At the time of placing the stove, the chimney flue
must be clean, leak-proof and without obstructions,
and must have a diameter of 150 mm.
• Any bends in the flue tube must not exceed 45
degrees.