Selecting The Temperature; Select Heat Setting; Switching On The Fan - SilverCrest SKD 2300 B2 Mode D'emploi

Selecting the temperature

NOTE
► The display
temperature
► The temperature measurement is made by the temperature sensor
may take some time until the whole room has reached this temperature.
♦ Press the button
temperature display uses °C or °F.
The selected unit of measurement
♦ Press the "Increase temperature" button,
temperature
The selected target temperature
♦ Press the "Decrease temperature" button,
temperature
The selected target temperature

Select heat setting

The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■ Level 1: 1000 watts
■ Level 2: 1300 watts
■ Level 3: 2300 watts
♦ Press the button to select the heat setting
desired heat setting has been set.
The selected heat setting

Switching on the fan

The appliance has a fan which can be used to distribute heated air throughout
the room more quickly.
♦ Press the fan button
If the fan is running, the "Fan" symbol
NOTE
► If the fan is switched off, the heat is concentrated more around the appli-
ance and is not distributed so quickly around the room.
│ GB │ IE
■ 14
shows the set target temperature
2
.
20
or 28 to select the unit of measure, to select whether the
23
13
up to a maximum of 37°C (99°F).
19
19
down to a minimum of 5°C (41°F).
19
19
10 is shown on the display
14 or to switch the fan on or off.
27
and measured actual
19
is shown on the display
or , to increase the target
15 32
is shown on the display
or 29 , to decrease the target
16
is shown on the display
or repeatedly until the
24 26
.
2
11 appears on the display
. It
7
.
2
.
2
.
2
.
2
SKD 2300 B2