Sauder Avenue Eight Executive Desk 416513 Mode D'emploi page 23

Step 16
NOTE: You may need someone's help to hold the BACK in
å
place while fastening to your unit.
Fasten the BACK (I) to the RIGHT END (B) and RIGHT
å
UPRIGHT (D). Use four BLACK 9/16" LARGE HEAD
SCREWS (1S) through the ANGLE BRACKETS on the END
and UPRIGHT.
Fasten the BOTTOM MOLDINGS (RR and TT) to the
å
BOTTOMS (G). Tighten eight HIDDEN CAMS.
These holes must be
closer to this edge.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
I
RR
Start
Arrow
Flat surface
TT
D
G
TT
B
416513
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
G
Edge should be even with
the surface of UPRIGHT.
Tighten
Arrow
Maximum
210 degrees
Minimum
190 degrees
1S
Flat surface
RR
Page 23