Sauder Avenue Eight Executive Desk 416513 Mode D'emploi page 10

Step 3
NOTE: Before beginning this step, separate the NARROW EXTENSION
å
SETS (AAA and BBB) from the WIDE EXTENSION SETS (CCC and DDD).
Do not confuse these SETS once they are separated.
Separate the NARROW EXTENSION SLIDES (BBB) from the NARROW
å
EXTENSION RAILS (AAA) as shown in the upper diagram below. Be prepared,
the parts are greasy.
Fasten the NARROW EXTENSION RAILS (AAA) to the ENDS (B and C) and
å
UPRIGHTS (D and E). Use sixteen GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to
fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
AAA
Open end
Page 10
BBB
Push the release lever in and pull the SLIDE from the RAIL.
AAA
C
AAA
Open end
Open end
AAA
AAA
E
AAA
D
416513
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
AAA
Open end
AAA
AAA
B
www.sauder.com/services
3S