Troubleshooting; Error Codes; Console - virtufit VFFOBRTABL Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
When replacing batteries, it is recommended to replace all
batteries, do not mix old and new batteries.
It is recommended to use alkaline batteries, they have a longer
life than normal batteries.
Batteries should be replaced when the display loses brightness
or stops showing.
Battery replacement
If the display is not accurate, it is recommended to replace the
batteries.
Use 4 x 1.5 AA batteries for power.

TROUBLESHOOTING

The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, contact the supplier.
Exercise bike squeaks: Check that all bolts and nuts are tight. If
necessary.
Ticking noise when pedalling: This may be caused by one of the
pedals. Remove the pedal(s) and mount it (them) correctly on the unit.
Tighten the pedal(s) firmly. If this does not solve the problem, contact
the supplier.
NOTE!
The "R" (right) pedal must be mounted clockwise and the "L"
(left) pedal must be mounted counter-clockwise.
The hand sensors are not working properly: Wash your hands, dry
them well and test the hand sensors again. If this does not solve the
problem, check the handlebar cables for damage and ensure that they
are properly connected to the connector. If this still does not correct
the problem, replace the handlebar.
Console does not work: If there is no signal when pedalling, check that
the cable is correctly connected.

ERROR CODES

E1:
Motor does not work (motor problems)
Solution: This problem may be caused by the motor having
difficulty adjusting its resistance, resulting in a loud motor noise.
When this happens, the motor may be possibly damaged by
a malfunction. If this does not solve the problem, contact the
supplier.
There is a problem with the cables
Solution: Check that the cables are not damaged or that they
cannot cause a short circuit.
The console has a problem.
Solution: Replace the console
E2:
A problem with the cables
Solution: Make sure the cables are not damaged or have the
potential to short.
There is a problem with the console:
Solution: Replace the console.
There is a problem with the motor:
Solution: Replace the motor.
E3: There is a problem with the cables.
Solution: Make sure the cables are not damaged or short-
circuited.
E4: During the body fat analysis, the first 8 seconds do not detect
the heart.
Solution: Wash your hands, dry them well and retest the hand
sensors. Hold the handles firmly with both hands.
CONSOLE (FIG. A)
SCAN
SPEED
DISTANCE
TIME
TIME Press the MODE button until the TIME function is selected.
The total cycle time from start to finish is displayed.
SPEED Press the MODE button until SPEED is selected. The
speed is displayed when you start the exercise.
CALORIES Press the MODE button until CALORIES is selected.
The total number of calories from the beginning to the end of
the exercise is displayed.
DISTANCE Press the MODE button until DISTANCE is selected.
The distance of each exercise is displayed when you start
exercising.
ODO The distance is automatically added when you start the
exercise.
PULSE Press the MODE button until PULSE is selected. Keep
your hands on the sensor for 3 seconds to display your heart rate.
ODO
CALORIES
PULSE
11

Publicité

Table des Matières
loading

Table des Matières