Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch PWS 1000-125 Notice Originale

OBJ_BUCH-1961-008.book Page 24 Friday, May 20, 2016 1:14 PM
24 | English
Cutting Stone
 Provide for sufficient dust extraction when cutting
stone.
 Wear a dust respirator.
 The machine may be used only for dry cutting/grinding.
For cutting stone, it is best to use a diamond cutting disc.
When using the cutting guide with dust extraction protection
guard 19, the vacuum cleaner must be approved for vacuum-
ing masonry dust. Suitable vacuum cleaners are available
from Bosch.
For cutting especially hard material, e. g., concrete with high
pebble content, the diamond cutting disc can overheat and
become damaged as a result. This is clearly indicated by cir-
cular sparking, rotating with the diamond cutting disc.
In this case, interrupt the cutting process and allow the dia-
mond cutting disc to cool by running the machine for a short
time at maximum speed with no load.
Noticeably decreasing work progress and circular sparking
are indications of a diamond cutting disc that has become
dull. Briefly cutting into abrasive material (e. g. lime-sand
brick) can resharpen the disc again.
Information on Structures
Slots in structural walls are subject to the Standard DIN 1053
Part 1, or country-specific regulations.
These regulations are to be observed under all circumstanc-
es. Before beginning work, consult the responsible structural
engineer, architect or the construction supervisor.
1 609 92A 1ZV | (20.5.16)

Maintenance and Service

The machine must al-
ways work in an up-
grinding motion. Other-

Maintenance and Cleaning

wise, the danger exists
 Before any work on the machine itself, pull the mains
of it being pushed un-
plug.
controlled out of the
 For safe and proper working, always keep the machine
cut.
and ventilation slots clean.
When cutting profiles
 In extreme conditions, always use dust extraction as
and square bar, it is best
far as possible. Blow out ventilation slots frequently
to start at the smallest
and install a portable residual current device (PRCD).
cross section.
When working metals, conductive dust can settle in the in-
terior of the power tool. The total insulation of the power
tool can be impaired.
Please store and handle the accessory(-ies) carefully.
If the replacement of the supply cord is necessary, this has to
be done by Bosch or an authorized Bosch service agent in or-
der to avoid a safety hazard.

After-sales Service and Application Service

Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Switch on the machine
Bosch's application service team will gladly answer questions
and place the front part
concerning our products and their accessories.
of the cutting guide on
In all correspondence and spare parts orders, please always
the workpiece. Slide the
include the 10-digit article number given on the nameplate of
machine with moderate
the product.
feed, adapted to the ma-
Great Britain
terial to be worked.
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: (01) 4666700
Fax: (01) 4666888
Bosch Power Tools