brondell Swash CL2200 Mode D'emploi page 24

PRODUCT OPERATION
Expert Mode Operations Level 2
Expert Mode Operations Level 2 allows for
customizing and changing the cycle times for
Rear Wash, Front Wash, Strong Wash, Warm Air
Dryer, Gentle Wash, and Gentle Wash Dry Cycle.
1. Enter Expert Mode
Level 2
1. Press/hold STOP
& Nozzle Cleaning
for 2 seconds.
2. Nozzle Cleaning
LED starts blinking
to indicate Special
Mode has been
entered.
3. Turn OFF seat
sensor - place hand
on right area of
seat.
4. Blue circle LED
light on remote
turns OFF = Seat
Sensor OFF.
24
2. Changing
Cycle Times
Rear Wash
(default 2 min)
1. Press/hold Rear
& Water Temp
together.
2. Water Temp light
blinks.
3. Continue to press
Rear without
releasing.
4. Press Water Temp
to select new cycle
time with LED light.
OFF=1 min
Green=2 min
Yellow=3 min
Red=5 min
5. Release to set
new time.
Custom programming must be performed in
Expert Mode status with the seat sensor overridden
and turned off, and with the seat unoccupied.
Using the remote, follow steps 1-3 to enter,
program, and exit Expert Mode Level 2.
Front Wash
(default 2 min)
1. Press/hold Front
& Water Temp
together.
2. Water Temp light
blinks.
3. Continue to press
Front without
releasing.
4. Press Water Temp
to select new cycle
time with LED light.
OFF=1 min
Green=2 min
Yellow=3 min
Red=5 min
5. Release to set
new time.
Strong Wash
(default 2 min)
1. Press/hold Strong
& Water Temp
together.
2. Water Temp light
blinks.
3. Continue to press
Strong without
releasing.
4. Press Water Temp
to select new cycle
time with LED light.
OFF=1 min
Green=2 min
Yellow=3 min
Red=5 min
5. Release to set
new time.