Using The Surface Brush On Rough Surface Structures - Gloria PowerBrush SpeedControl Mode D'emploi

Place the device parallel with the surface
16
and side brush on the surface to be treat-
ed. Hold the device at working angle and
make sure that the brush strip on the safe-
ty guard (L) is just above the ground and
that the bristles of the side brush (J) touch
the wall.
Walk at an even steady pace and push the
device in front of you.
Depending on the degree of soiling,
apply light to medium pressure on the
surface brush, adapt your pace of work
to the degree of soiling.
NOTE!
If you now wish to clean the other
side in the same direction or seam-
lessly clean a corner of the house,
you can convert the device accord-
ingly. To do so, proceed as follows:
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!
Switch the device off by releasing
the ON/OFF safety switch (D).
Loosen the screw connection (G) on
17
the telescopic tube (F) and then use
the telescopic tube (F) to turn the
handle (A) by 180° as illustrated.
Adjust the length of the telescopic
tube (F) again according to your body
height.
NOTE!
In this work step, you will change the
direction of rotation of the surface
brush (M).
"1." Use the screw connection (G) to
18
tighten the telescopic tube (F) again so
that it is hand-tight. Now turn the
entire device by 180° as shown in the
figure in "2.".
NOTE!
In this work step, you will turn round
the open side of the device, i.e. the
side brush will be turned to the other
side. This once again ensures the cor-
rect direction of rotation of the surface
brush.
CAUTION! RISK OF INJURY DUE TO
INCORRECT DIRECTION OF
ROTATION OF THE SURFACE
BRUSH!
The working direction of the device
must ALWAYS be away from you,
so you have to pull.
Now adjust the 5 click-stop safety guard
19
(L) so that the brush strip is just above the
ground and clean the surface facing it.
NOTE!
20
21
+
With this method of double-
sided cleaning, you can seam-
lessly work on surfaces that
end at wall corners.
Disassembly is carried out in reverse
22
order ( ).
6.1.3 Using the surface brush on
rough surface structures e.g. tiles,
paving slabs, exposed aggregate
concrete, stoneware etc.
Place the switched-on device parallel on
the surface to be treated. Hold the device
at working angle and make sure that the
brush strip on the safety guard is just
above the ground.
Walk at an even steady pace and push
the device in front of you.
Depending on the degree of soiling,
apply light to medium pressure on the
surface brush, adapt your pace of work to
the degree of soiling.
25