Table des Matières
Publicité
3000 Series
Art. 3171
Digital intercom
PROGRAMMING
PHONE ID
Phone ID is made by setting the internal 8 way dip-switch to the positions shown on decimal/binary conversion table on pag.3
of this manual.
SET THE MELODY
• Press and hold (for approx 10 seconds) the
the unit plays the current programmed melody and emits a
beep at the end.
• Press again the
button to listen to the available melodies
(maximum 9, see the table right).
• Once the selected melody has been reached, wait 5 seconds
for a beep. The new melody will be stored.
SET THE NUMBER OF RINGS
The default setting is 6 rings with melody 1.
To set 3 rings:
• Disconnect the L wire from the intercom;
• Press and hold the
To set 6 rings(NOTE: the melody will be restore to medody 1):
• Disconnect the L wire from the intercom;
• Make a wire link between – and LB;
• Reconnect the L wire;
• Remove the link between – and LB as soon as the intercom emits two confirmation beeps.
CONNECTION TERMINALS SIGNALS
L
"BUS" bus connection
–
LB
Local bell input (short to - to trigger)
AL
Alarm input (short to - to trigger).
The alarm generated by this input will be sent to the
concierge (if present) and will be intercepted by the
Art. 512DR if present and correctly configured
SW
Service push button terminals (Max 30Vac/dc 0,2A)
SW
Art. 3171
- Installation instructions
button while reconnecting. The intercom emit one confirmation beep.
button until
Melody
Melody 1
Melody 2
Melody 3
Melody 4
Melody 5
Melody 6
Melody 7
Melody 8
Melody 9
TECHNICAL SPECIFICATION
Addressing range:
Power Supply:
Power Consumption:
- 2 -
Frequency
Tone
High
Medium
Single high-pitched
Low
High
Medium
Double low-pitched
Low
High
Medium
Triple high-pitched
Low
from 1 to 180 (BIN code)
BUS line Voltage
Stand-by:
Max:
66251345 - V1.2 - 31/03/22
0.6mA
80mA
Publicité
Table des Matières
